clack box elbow

[CL engineering]

Hi all
we need the elbow that go's on the bottom of the clack box's on our Marshall need 2 of them.
before we make a pattern dose any one have a pattern they could hire or sell us? or a old one they would like to sell

also need the small elbow that go's on top of the block were the oil go's in

thanks for help
Chris and Laura

[ashpan]

Dear sir
I have a brass cast elbow which is new and unmachined, I think I have still got the pattern to cast another one it would be helpful if you could let me have some sizes. My number is 01665 711137 after 8pm.
Yours
Peter Thompson

[merryweather]

Hi Peter, Chris,

I also need two elbows for the displacements that feed the valve chest and the gov. valve. Happy to share the costs etc...

Roger

07952 386 837

[bill]

hi
Ive just had a pattern and castings done for this elbow if the same

dimensions as cast
flange diam 41/4"
hieght from flange to centre of tapped boss 31/8"
diam of tapped boss 2"
diam of upright 11/2"

if suitable youre welcome to borrow it

Bill 07904867088 lancs

[CL engineering]

thanks ever one for your help will give you all a ring Wednesday night
thanks Chris

[STERVAN]

I'm looking for the flanged elbow that goes on the water pump clack box if there's any patterns about.