Fowler BB1 Ploughing Engine Road Gear - Traction-Talk

dickeastwood · #1 Post / In Thread 5th January 2009, 04:55 PM

Can anyone help me find a new Road Spur Pinion (the final drive gear) for a 1919 Class BB1 Ploughing Engine which we are rebuilding? Details from Fowler Dwg. No. 61704 are 12 teeth at 2 3/4" pitch on 10.5" diameter. Williams Team Owner/Manager Dave (Engines) at Hay on Wye, Hereford can collect!
Appreciate any assistance - to this, my first attempt to post a thread.

feet n inches · #2 Post / In Thread 5th January 2009, 05:00 PM

Hi there,
I have a spare one in the garage, it came with my AA7 but did not fit. I will measure it up as soon as I can and get back to you.

Regards
Steve

dickeastwood · #3 Post / In Thread 5th January 2009, 05:12 PM

Hi there Steve,
I am amazed that it took only 5 minutes for your reply! What an amazing web site.
I have the drawing beside me and the details are as follows:
12 teeth at 2 3/4" pitch on 10.5" diameter (centre of the teeth depth?)
Outside Diameter of gear is 12 1/4"
Inside Diameter (for shaft) is 4 5/8"
2 keyways 1 1/4" wide and 7/16" deep @ 1/3 (of circumference) apart

If we have a match would be pleased to exchange contact details.
Many thanks
Dick

The Pirate · #4 Post / In Thread 5th January 2009, 10:13 PM

That's certainly cheaper than all my suggestions the other day.

feet n inches · #5 Post / In Thread 8th January 2009, 09:59 PM

Hi Dick,
Just to let yu know that I have'nt forgotten you, its just been too cold to enter the garage. (its been s cold the coolant has frozen in one of the lathes) I hope to pry the door open tomorrow.
Cheers
Steve

richbart01 · #6 Post / In Thread 9th January 2009, 07:02 AM

Quote:

Originally Posted by feet n inches

Hi Dick,
Just to let yu know that I have'nt forgotten you, its just been too cold to enter the garage. (its been s cold the coolant has frozen in one of the lathes) I hope to pry the door open tomorrow.
Cheers
Steve

I thought you valley's boys were a tough lot steve !! , a bit of frost & the ploughing crew grind to a halt

happy new year to all there steve

Richard

feet n inches · #7 Post / In Thread 9th January 2009, 07:06 PM

Oh sorry, what I meant to say was "the other half wont let me out" and believe me they are tougher than us lads.

Steve

BB1 MR JOHN · #8 Post / In Thread 18th January 2009, 06:39 PM

i have a worn gear that could be restored with weld if you are missing this gear.

dickeastwood · #9 Post / In Thread 26th January 2009, 06:24 AM

Quote:

Originally Posted by BB1 MR JOHN

i have a worn gear that could be restored with weld if you are missing this gear.

Much appreciate your help. We have the gear - but in the (still) unsuccessful attempts to remove it from the shaft it is now looking decidedly worse for wear!
Can you please contact me regarding details,
Cheers,
Dick