WANTED lathe
Hi all
I have recently just bought the castings and boiler for a 4" little Sampson and I currently don't have a suitable lathe so I'm after something like a myford ml7 or larger. I have an 8' gap in the workshop now however a lathe that size would be rather too large I surspect. The rear wheels are 18" so that would be amazing if it was about to machine that however I can find other places to machine them. Finally I don't mind if it is three phase or not as I'm able to just swap over the motors if necessary
Based in Exeter so the closer the better
Thanks James
|
12th July 2015, 08:14 PM
Threaded Mode