|
|
|||||||
| Register | Donate | Events Calendar | Picture Albums | Mark Forums Read |
| Wanted Adverts Steam items and equipment Wanted. |
 |
|
|
Thread Tools | Display Modes |
28th May 2017, 03:33 PM
|
||||
|
||||
aveling fire hole door
Need a new firehole door for our e-type.
Anyone git one or pattern we could borrow to get one cast please? 
|
|
28th May 2017, 09:23 PM
|
||||
|
||||
|
What size is it. May have a pattern.
Sent from my iPhone using Tapatalk
|
|
30th May 2017, 05:47 PM
|
||||
|
||||
|
Quote:
Will have a measure up later this week Sent from my iPhone using Tapatalk
|
| The Following User Says Thank You to single speed For This Useful Post: | ||
|
3rd June 2017, 12:59 PM
|
||||
|
||||
|
Looking for a 10 3/4" diameter door
 Sent from my iPhone using Tapatalk
|
|
3rd June 2017, 01:47 PM
|
||||
|
||||
|
Thanks, I think ours is for a 10x9 hole, so may not work. Will go up the yard in the morning and have a measure. It might work as you have a flat bit. I try to post a picky.
Cheers Douglas
|
|
3rd June 2017, 02:05 PM
|
||||
|
||||
|
Ok thanks
Sent from my iPhone using Tapatalk
|
|
7th June 2017, 05:43 AM
|
||||
|
||||
|
Yes Jim, quite different shape, for an oval door. Also it was a spare casting I had, but it was not my pattern it was from.
Sent from my iPhone using Tapatalk
|
| The Following User Says Thank You to avelingporter For This Useful Post: | ||
|
12th June 2017, 08:34 AM
|
|||
|
|||
|
Firedoor
Hello been a while since I was last on this site just wondering if you managed to get a pattern and where do you normally source your castings from since I have a small ferrous and non ferrous foundry situated just out side Stourbridge in the West Midlands maybe you would like to send me amessage thank your
|
|
15th September 2020, 02:20 PM
|
||||
|
||||
|
Did you manage to get one, Stuart?
I could do with one now!
__________________
Roll on steamy days! !
|
|
| Thread Tools | |
| Display Modes | |
|
|
 |
 |
 |
 |
 |
 |
Linear Mode
