aveling fire hole door
 

Need a new firehole door for our e-type.
Anyone git one or pattern we could borrow to get one cast please?

What size is it. May have a pattern.


Sent from my iPhone using Tapatalk

Will have a measure up later this week


Sent from my iPhone using Tapatalk

Looking for a 10 3/4" diameter door
https://uploads.tapatalk-cdn.com/201...87813ff65a.jpg


Sent from my iPhone using Tapatalk

Thanks, I think ours is for a 10x9 hole, so may not work. Will go up the yard in the morning and have a measure. It might work as you have a flat bit. I try to post a picky.

Cheers
Douglas

Ok thanks


Sent from my iPhone using Tapatalk

That one you got for John Ralphs was ok. Is there much difference in size?

Yes Jim, quite different shape, for an oval door. Also it was a spare casting I had, but it was not my pattern it was from.


Sent from my iPhone using Tapatalk

Firedoor
 

Hello been a while since I was last on this site just wondering if you managed to get a pattern and where do you normally source your castings from since I have a small ferrous and non ferrous foundry situated just out side Stourbridge in the West Midlands maybe you would like to send me amessage thank your

Did you manage to get one, Stuart?

I could do with one now!